Cavity Weep™

Cavity Weep^TM is superior to other weep hole/weep vent products because it creates multiple tunnels allowing water to exit the cavity by running on the top surface of the flashing.  It puts the weep holes at the lowest point of the wall, beneath the bed joint of mortar!

Features/Benefits

• It forms the bottom side of the bed joint of mortar creating 4 weep holes every 9.5”
• Doesn’t impede the flow of water or create artificial dams that impede drainage
• Installs quickly saving time and money
• Translucent in color to blend with mortar

Weeps Incidental Moisture in

• Brick Cavity Walls
• Single-Wythe Walls

(Cavity Weeps is also known as Cavity Vent)

• Place Cavity Weep^TM on flashing with continuous belt centered in the cavity and legs extending out from face of wall about 1” to 1.5”
• Place bed joint of mortar on Cavity Weep^TM and lay masonry units
• Tool joints and lightly score legs at face of wall; crack off by pushing downward while mortar is still plastic
• Finish tool joint and brush

Contact MTI at 1-800-879-3348 for specific cost to your destination.

Cavity Weep Specifications

MTI Cavity Weep (CV 5010); 2 1/4" (57 mm) wide weep legs at 9 1/2" (241 mm) on center; continuous belt 1" (25.4 mm) wide; and total width of 6" (152mm).